BASIC Toolbar AutoCAD 2

Learn Basic Toolbar CAD 2

Hello, see you again, best wishes to all, success is my right, You and all, "Bu Pa Bu Hou Yao, Hui, 15 Wisdom Sucsess Andrie Wongso. 

Carefully read this article! do not read completely before You try a little by little practice on a computer, such as riding a bike, book (writing) a theory of no use if it's not practice, don't be afraid also do mistakes, learning to ride a bicycle much of the fall, do not cause this eventually learned my lesson will open science as well as a new experience.

General Description ToolbarCAD. Ok, here we go; 

1. F6 = on button f6 generally and is one which used to be able to view each design 3D (three demensi) and 2D (two demensi), but it is a rare pengunaannya. 

2. F7 = on button f7 useful for men (On/Off) grid on screen autoCAD, example; press f7 then the grid on the screen can be seen. 

3. F8 = f8 key useful to help line on a horizontal and vertical position as well as if in On it, then korsur can move freely. 

4. F9 = key f9 is men (On/Off) to snap and grid, snap and grid can we decide on its own, later discussed in the next Chapter. 

5. F10 = on the key f10 is to download (On/Off) polar angular lines generally in use, later discussed on the next Chapter.

6. F11 = key f11 is to download (On/Off) object snap tracking or can also be called the small dashed. 

7. F12 = on button f12 key or the end of the known and also the dynamic input, useful for meinputkan a line we have specified, and the line angle also can we set without pressing enter, for example; press line and then press f12, give numbers on the line and then enter one (1) time, then tilt the line with an angle of 45 (forty five) degrees, give numbers on the line are the two (2) press enter two times. Then the line and these can form an angle already. 

On discussion of learning CAD Toolbar or f1-f12 function has been completed, the next Writer will start again with a new Chapter to learn basic ACADstandart, the end of the useful and authors wish to thank you all.